Cisco ASR1002-5G-SHA/K9 Software Guide - Page 302

Configuring Synchronous Ethernet Chapter 10 Synchronous Ethernet Support Step 5 Command interface gigabitethernet slot/port Step 6 Example: Router(config)# int gig 0/0/0 synchronous mode Purpose Specifies the Gigabit Ethernet interface to be configured: slot/port-Specifies the location of the interface. Sets the mode to synchronous mode. Step 7 Example: Router(config-if)# synchronous mode exit Exits the global configuration mode. Step 8 Example: Router(config)# exit network-clock input-source priority {interface interface_name slot/card/port | {external slot/card/port }} Enables clock recovery from SyncE. ASR1006 router supports two RP ports, one is active and the other is standby. Both the active and standby RP BITS ports can be configured as input source. Example: Router(config)# network-clock input-source 1 interface GigabitEthernet0/0/0 Step 9 Router(config)#network-clock input-source 1 external R0 e1 cas crc4 exit Exits the global configuration mode. Examples Example: Router(config)# exit The following example shows how to configure clock recovery from SyncE: Router>enable Router# configure terminal Router(config)# network-clock synchronization automatic Router(config)# network-clock synchronization ssm option 2 GEN1 Router(config)# int gig 0/0/0 Router(config-if)# synchronous mode Router(config)# exit Router(config)# network-clock input-source 1 interface GigabitEthernet0/0/0 Router(config)# exit 10-6 Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide OL-16506-10