Cisco ASR1002-5G-SHA/K9 Software Guide - Page 303
Configuring Clock Recovery from a BITS Port, con terminal, network-clock input-source, interface
View all Cisco ASR1002-5G-SHA/K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 303 highlights
Chapter 10 Synchronous Ethernet Support Configuring Synchronous Ethernet Configuring Clock Recovery from a BITS Port This section describes how to configure clock recovery from BITS port. SUMMARY STEPS 1. enable 2. configure terminal 3. network-clock synchronization automatic 4. network-clock synchronization ssm option option_Id Generation_Id 5. network-clock input-source priority {interface interface_name slot/card/port | {external slot/card/port }} 6. exit DETAILED STEPS Step 1 Command enable Step 2 Example: Router# enable configure terminal Purpose Enables the privileged EXEC mode. Enter your password if prompted. Enters the global configuration mode. Step 3 Step 4 Example: Router# configure terminal network-clock synchronization automatic Enables the network clock selection algorithm. This command disables the Cisco-specific network clock Example: Router(config)# network-clock process, and turns on the G.781-based automatic clock selection process. synchronization automatic network-clock synchronization ssm option {option_id {GEN1 | GEN2}} Example: Router(config)# network-clock synchronization ssm option 2 GEN1 Configures the equipment to work in synchronization network. The option_id value 1 refers to synchronization networks design for Europe. This is the default value. The option_id value 2 refers to the synchronization networks design for the U.S. OL-16506-10 Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide 10-7