Cisco WS-C4928-10GE Installation Guide - Page 59
show power, Troubleshooting the Installation
View all Cisco WS-C4928-10GE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Chapter 3 Installing the Switch Connecting DC Power to the Switch Step 5 Step 6 Step 7 Step 8 Replace the safety cover over the power terminals. Connect the other end of the power cables to an DC-power input source. If both power supplies will be used, make sure they are on different circuits. Turn on the power from the power source. The DC supply does not have an on/off switch. Verify power supply operation by looking at the front panel power supply LEDs: • The PS1 or PS2 LED is green when the power supply is functioning normally. • The PS1 or PS2 LED is red when the power supply is not functioning normally. • The PS1 or PS2 LED is off when the power supply is not connected to a power source. From the system console, enter the show power command to display the power supply and system status. For more information on this command, see the command reference publication for your software release. If the LEDs or show power command indicate a power or other system problem, see Chapter 5, "Troubleshooting the Installation," for troubleshooting information. 78-18039-02 Catalyst 4900 Series Switch Installation Guide 3-13