Clifford ACE 500 Owners Guide - Page 12
Valet mode, Selectable starter/ignition interrupt, Dual-Level Tamper Warning - wiring
View all Clifford ACE 500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Valet mode Whenever the system is put in valet mode, all of the system's security features are switched off. At various times, you will need to turn the system off. For instance, when having your car serviced, washed or parked by a valet. NOTE: If you temporarily lose the use of your remote controls, you can disarm the system by enabling valet mode. To enable valet mode 1. Turn the ignition switch to its "ON" position or start the engine. 2. Flip the valet switch. The system's LED will glow for on-going confirmation. To exit valet mode 1. Turn the ignition switch to its "ON" position or start the engine. 2. Flip the valet switch. The system's LED will turn off to confirm that the system is in its normal operating mode. Remote controlled valet mode entry and exit You can even remotely enable or exit valet mode. All you need to do is transmit channel 5 (one press of the side LevelShift button, then button 1). In addition to the previously noted indications, two parking light flashes will confirm that you have remotely enabled valet mode, while a single flash confirms exiting of valet mode. Keyless entry in valet mode Even in valet mode, you can still activate convenience features. Press button 1 as if you were disarming and the doors will unlock (indicated by one parking light flash) and the interior light will turn on. Press button 1 again and the doors lock (two flashes). Selectable starter/ignition interrupt At the time of installation, you can select whether your ACE 500 interrupts the starter line or the ignition line. The starter/ignition interrupt will be set in either Fault-Proof mode, which lets you start the engine even in the unlikely event of a complete system failure, or Super-Security mode that ensures a thief won't be able to start the engine even if he cuts all the wires or finds the system control unit and disconnects it. Changing the mode requires a minor relay wiring change and installer-only programming. Your local Authorized Clifford Dealer can make the changes for you. Dual-Level Tamper Warning You may set the sytem to issue a rapid five-chirp warning, instead of the full alarm, whenever the system detects tampering. If there is any further tampering, or if a door, the hood or the trunk is opened at any time, your system will sound the full alarm. See User-selectable features on page 15-16. 11