Cobra 29 LTD CHR 29LTDCHR_MANL - Page 7
To Receive - 40 channel
View all Cobra 29 LTD CHR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Operation To Receive Operation To Receive Note The reading will be slightly higher on Channels 1 and 40 compared to Channel 20. Note When switched to SWR position the meter needle should ideally be as far to the left as possible. Anything over 3 is not acceptable. The antenna indicator will light. A slight antenna height adjustment (higher or lower) may be required. Repeat relcalibration steps. 5 While still holding down the mic button, set the S/RF SWR CAL switch to the SWR position, to read the SWR reading. 6 Repeat the same steps two through five on Channel 1 and 40. This will check SWR for all channels. 1 Rotate the On/Off Volume knob clockwise the green RX/TX LED will be illuminated. 12 13
Operation
13
Operation
12
Note
The reading will be slightly
higher on Channels 1 and 40
compared to Channel 20.
Note
When switched to SWR position
the meter needle should ideally
be as far to the left as possible.
Anything over 3 is not
acceptable. The antenna
indicator will light. A slight
antenna height adjustment
(higher or lower) may be
required. Repeat relcalibration
steps.
Repeat the same steps two through five
on Channel 1 and 40. This will check SWR for
all channels.
6
While still holding down the mic button, set
the S/RF SWR CAL switch to the SWR position,
to read the SWR reading.
5
Rotate the
On/Off Volume knob
clockwise
the green RX/TX LED will be illuminated.
To Receive
1
To Receive