Coby CTP9050 Operation Guide - Page 10
Telephone, Setup, Battery, Installation
View all Coby CTP9050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
TELEPHONE SETUP Tone / Pulse Switch O 0 Tone / Pulse Swift 1. Choose the correct dialing mode. 2. Select the dialing mode Tone or Pulse by setting the switch at the back of the base unit. Note: Changes to the switch position during a call do not take effect until the call has ended. Tip:lf you are unsure of the proper dialing mode, make a trial call with the dial mode setting to TONE. If the call connects, leave the switch as is (TONE mode), otherwise, set to PULSE. BATTERY INSTALLATION To install the 3.6V 600mAh cordless handset battery pack: 1.Slide open the battery compartment door on the back of the handset. 2.Plug the battery connector into the 2-pin connector in the battery compartment, and then insert the battery. 3. Close the battery compartment door. 4. Place the handset on the base unit cradle. 5. Once you have installed the battery pack and placed The handset on the base you will hear a tone indicating The handset has connected with the base and will successfully charge. 6. IMPORTANT: Charge the battery pack for at least 12 hours before using the handset the first time. 7. The CHARGE LED on the base illuminates when the handset is properly making contact with the charge terminals. Battery Duration A fully charged battery lasts for approximately: • 5 hours when you use the handset continuously (talk time). • 5 days when the handset is not in use (standby). When the Battery Needs Charging • The display will show "LOW BATTERY•'. LCii BATTERY When to Purchase a New Battery pack If the battery lasts only a few minutes even after a full charge, the usable life of the battery has expired and needs to be replaced. Replacement batteries can be purchase in every supermarket , or you can contact COBY ELECTRONICS CORP. customer service dept for information about how to order a new bat ery. 8