Coby CTP9050 Operation Guide - Page 11
Handset, Basic, Displays, Operation
View all Coby CTP9050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
HANDSET AND BASIC DISPLAYS The Headset Jack The headset jack is located on the side of the handset and is a standard 2.5mm plug. Simply plug the headset into the jack and the headset will be active. Note: When the headset is plugged into the telephone, the microphone and earpiece on the handset are not active. Ball Clap Belt-Clip Be sure to remove the belt-clip filler cap prior to installing Belt-clip. Install the belt-clip as shown. To remove the belt-clip, squeeze the release at the top of the clip where it attaches to the phone, and gently Pull the clip up and out of the handset. HEADSET Jack Basic Displays Headset Idle Line Muted MUTE 555- 12 12 Volume Control UfiL :t1ID 555- 12 12 us- Call Timer 555- 12 12 New CID Received HEW CALL: 02 Oft-hook TALK BASIC OPERATION Making Calls 1. Pick up the handset from the base and press CID TALK 2. Wait until you hear a dial tone, and then dial he number You wish to dial. 3. When you are finished talking, press the CS) key or place the unit back into the base to end the call. Note: The IN USE CHARGE light on the base will illuminate when the line is active. Receiving Calls When you hear the phone ring: 1. If the handset is in the base, lift the handset from the base. The handset will turn on. There is no need to push the CID key if the unit is on the base when the call comes in. This auto-answer feature can be programmed off (see handset settings page 13), 2. If the handset is off the base, you will need to press CI) to answer the call. The display will show the caller ID information after the first ring. TALK 3. When you are finished, push CID or place the handset back on the base. 9