Compaq 321 Compaq 320, 321, 420, 421, 620, 621 Notebook PCs and HP 420, 620 No - Page 89
Remove the power switch board, and then slide the board out of the retainer
View all Compaq 321 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
Remove the power switch board: 1. Release the ZIF connector (1) and disconnect the ribbon cable (2) from the system board. 2. Remove the Phillips M2.5×3.0 broadhead screw (1) that secures the board to the base pan, raise the end of the board (2), and then slide the board out of the retainer (3). Reverse this procedure to install the power button board. Component replacement procedures 79
Remove the power switch board:
1.
Release the ZIF connector
(1)
and disconnect the ribbon cable
(2)
from the system board.
2.
Remove the Phillips M2.5×3.0 broadhead screw
(1)
that secures the board to the base pan,
raise the end of the board
(2)
, and then slide the board out of the retainer
(3)
.
Reverse this procedure to install the power button board.
Component replacement procedures
79