Compaq ProLiant 6400R Compaq Parallel Database Cluster Model PDC/O1000 for Ora - Page 151
Unable to Start OracleCMService, Installed, Products
View all Compaq ProLiant 6400R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 151 highlights
7-6 Compaq Parallel Database Cluster Model PDC/O1000 for Oracle8i and Windows 2000 Administrator Guide I Determine whether or not you need to deinstall a partial OSD installation. An incomplete installation can result in a partial installation of the OSDs on the cluster. If this occurs, you must clean up after the partial installation (by removing it) before you can successfully run the OUI again. An incomplete OSD installation could result for various reasons, for example: G A cable is no longer seated tightly into its connector. G The node from which you are running the OUI cannot communicate with all other nodes in the cluster. G The user running the OUI does not have administrator privileges on all cluster nodes. Refer to "Deinstalling a Partial OSD Installation" in Chapter 6, "Cluster Management," for information about how to remove a partial OSD installation. Unable to Start OracleCMService I Verify that the cluster interconnect is properly configured. I Make sure the OSDs have been properly installed on the nodes by running the OUI on the cluster's primary node. Click Installed Products and verify that an entry for the OSDs exists. I Verify that the OracleCMService has properly started by checking its error log. The default location for the error log is C:\compaq\ops\cmsvr.log. If not found in the default location, look in the same directory in which the OSD modules were installed. I Verify that the Node Manager Service, OracleNMService, is running. If not, see the error logs in C:\compaq\ops\nm.log. If OracleNMService is running, check the CM Server logs in C:\compaq\ops\cmsrvr.log. Attempt to start the OracleCMService again. I Check the event logs for errors. Be sure to check both the System and Application logs.