Craftsman 11580 Operation Manual - Page 10

A WARNING: Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. A WARNING: Always wear safety goggles or safety glasses with side shields when operating tools. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury. A WARNING: Do not use any attachments or acces- sories not recommended by the manufacturer of this tool. The use of attachments or accessories not recommended can result in serious personal injury. APPLICATIONS You may use this tool for the following purposes: [] Drilling in wood [] Drilling in ceramics, plastics, fiberglass, and laminates [] Drilling in metals [] Mixing paint [] Hammer drilling in concrete, brick, or other masonry This product will accept DieHarde_ 19.2 V lithium-ion battery packs and Craftsman 19.2 V nickel-cadmium battery packs. For complete charging instructions, refer to the Operator's Manual for the battery packs and chargers listed in the General Safety Rules. TO INSTALL BATTERY PACK See Figure 3. m Lock switch trigger on the drill by placing the direction of rotation selector in the center position. m Place battery pack in the drill. Align raised rib on battery pack with groove inside drill. CAUTION: When placing battery pack in the drill, be sure raised rib on battery pack aligns with groove inside drill and latches snap into place properly. Improper assembly of battery pack can cause damage to internal components. [] Make sure the latches on each side of the battery pack snap in place and battery pack is secured in drill before beginning operation. TO REMOVE BATTERY PACK See Figure 3. m Lock switch trigger on the drill by placing the direction of rotation selector in the center position. m Locate the latches on the side of the battery pack and depress to release the battery pack from the drill. m Remove battery pack from the drill. LATCHES DEPRESSLATCHESTO RELEASEBATTERYPACK Fig. 3 10