Craftsman 11580 Operation Manual - Page 11
hLWARNING:Batterytoolsarealways, inoperat, ingcondition., Therefore, switchshouldalwaysbe, SWITCH
View all Craftsman 11580 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
_hL WARNING:BatterytoolsarealwaysinoperatingconditionT. herefores,witchshouldalwaysbe lockedwhennot inuseorcarryingatyourside. SWITCHTRIGGER See Figure 4. To turn the drill ON, depress the switch trigger. To turn it OFF, release the switch trigger. VARIABLE SPEED The variable speed switch trigger delivers higher speed and torque with increased trigger pressure and lower speed with decreased trigger pressure. FORWARD/REVERSE/ CENTERLOCK FORWARD/REVERSE/CENTER LOCK See Figure 5. The direction of bit rotation is reversible and is controlled by a selector located above the switch trigger. With the drill held in normal operating position, the direction of rotation selector should be positioned to the left of the switch trigger for drilling. The drilling direction is reversed when the selector is to the right of the switch trigger. Setting the switch trigger in the OFF (center lock) position helps reduce the possibility of accidental starting when not in use. CAUTION: To prevent gear damage, always allow the chuck to come to a complete stop before changing the direction of rotation. To stop the drill, release the switch trigger and allow the chuck to come to a complete stop. NOTE: The drill will not run unless the direction of rotation selector is pushed fully to the left or right. Avoid running the drill at low speeds for extended periods of time. Running at low speeds under constant usage may cause the drill to become overheated. If this occurs, cool the drill by running it without a load and at full speed. SWITCH TRIGGER Fig. 4 NOTE: You might hear a whistling or ringing noise from the switch during use. Do not be concerned; this is a normal part of the switch function. FORWARD/ REVERSE/ CENTERLOCK REVERSE SWITCH FORWARD TRIGGER Fig. 5 11