Craftsman 11580 Operation Manual - Page 15

USING THE AUXILIARY HANDLE ASSEMBLY See Figures 12- 13. An auxiliary handle is packed with the drill for ease of operation and to help prevent loss of control. The handle can be rotated 360 ° , and it can also be mounted on the opposite side for left hand use. To adjust the auxiliary handle assembly, loosen the handle assembly by turning the handle counterclockwise. Rotate the auxiliary handle assembly to the desired operating position. Securely tighten by turning the auxiliary handle clockwise. Be sure the auxiliary handle is securely tightened against the depth gauge clamp. This secures the depth stop rod at the desired depth of cut. It also secures the auxiliary handle. NOTE: For convenience and ease of starting threads, the hex nut has been trapped inside the molded slot in the auxiliary handle. The depth stop rod helps control the depth of drilled holes. NOTE: When properly installed, the teeth on the depth stop rod should be aligned with the teeth indicator on the depth gauge clamp. Adjust the depth stop rod so that the drill bit extends beyond the end of the rod to the required drilling depth. When drilling holes with the depth stop rod installed, the desired hole depth has been reached when the end of the rod comes in contact with the surface of the workpiece. HEXBOLT PLATE AUXiLiARY HANDLE ADJUSTING THE AUXILIARY HANDLE ASSEMBLY See Figure 13. [] Loosen the auxiliary handle assembly by turning the knob counterclockwise. [] Rotate the auxiliary handle assembly to the desired location. [] Tighten the auxiliary handle assembly securely by turning the knob clockwise. ADJUSTING THE DEPTH STOP ROD See Figure 13. [] Lock the switch trigger by placing the rotation selector in the center position. [] Loosen the auxiliary handle assembly by turning the knob counterclockwise. [] Adjust the depth stop rod so that the drill bit extends beyond the end of the rod to the required drilling depth. [] Tighten the auxiliary handle assembly by turning the knob clockwise. DEPTHSTOPROD SCALE TEETH DRILL BIT TO INCREASE DRILLING DEPTH HEXSLOT HEX BOSS '0i_?TO TIGHTEN LOOSEN TO DECREASE DRILLING DEPTH TO TIGHTEN DRiLLiNGDEPTH Fig. 12 F0 LOOSEN Fig. 13 15