Craftsman 17776 Owners Manual - Page 11

Maintenance (cont.) C_eaning a Dry Fimter NOTE: For best results of cleaning due to accumulated dust, clean the filter in an open area, Cleaning SHOULD be done outdoors and not in the living quarters, 1, Some removal of dry debris can be accomplished without removing the filter from the vac by slapping your hand on top of the lid while the vac is turned off, 2, After filter removal from vac, remove the dry debris by gently tapping the filter against the inside wall of your dust drum and the debris will loosen and fall. 3, For thorough cleaning of dry filter with fine dust (no debris) you may run water through the filter as described under "Cleaning a Wet Filter". C_eaning a Wet Filter After filter is removed, a wet filter should be cleaned by running water through it from a hose of spigot. Take care that water pressure from the hose is not strong enough to damage filter, mnstaHation To ensure a proper seal, clean the lid area where the filter will seat. Slide the new filter over the filter cage.Refer for proper 'Filter Assembly". to page 6 To keep your Portable Wet/Dry Vac looking its best, clean the outside with a cloth dampened with warm water and mild soap. Portable Wet/Dry Vac Maintenance To keep your Portable Wet/Dry Vac looking its best, clean the outside with a cloth dampened with warm water and mild soap.To clean the drum: 1, Dump debris out, 2, Wash drum thoroughly with warm water and mild soap. 3, Wipe out with dry cloth, WARNING: To assure product SAFETY and RELIABILITY, repairs and adjustment should be performed by Sears Service Centers, always using Sears replacement parts. NOTE: If your casters are noisy, you may put a drop of oil on the roller shaft to make them quieter. 11