Craftsman 28907 Operation Manual - Page 21

Warning, To Avoid, Serious, Injury, Performing, Service, Or Adjustments, To Remove, Mower, Caution,

Get Craftsman 28907 - Lt 2000 19.5 HP/42inch Lawn Tractor PDF manuals and user guides View all Craftsman 28907 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

WARNING: TO AVOID SERIOUS iNJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: 1. Depress clutch/brake pedal fully and set parking brake. 2. Place gearshift lever in neutral (N) position. 3. Place attachment clutch in "DISENGAGED" position. 4. Turn ignition key to "STOP" and remove key. 5. Make sure the blades and all moving parts have completely stopped. 6. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. TO REMOVE MOWER 1. Place attachment clutch in "DISEN- GAGED" position. 2. Lower attachment lift lever to its lowest position. 3. Roll belt off engine pulley (M) and belt keepers (G). 4. Remove retainer spring (K), slide collar (L) off and push housing guide (P) out of bracket. 5. Remove clutch cable spring (Q) from idler arm (R). 6. Disconnect front link (E) from mower remove retainer spring and washer. 7. Go to either side of mower and disconnect mower suspension arm (A) from chassis pin (B) and rear lift link (C) from rear mower bracket (D) - remove retainer springs and washers. _f_ CAUTION: After rear lift links are discon- nected, the attachment lift lever will be spring loaded. Have a tight grip on lift lever when changing position of the lever. 8. Slide mower out from under right side of tractor. IMPORTANT: If an attachment other than the mower is to be mounted on the tractor, remove the front link (E) and rear lift links (C) from tractor and hook the clutch spring (Q) into the cable guide on front edge of lower dash. TO iNSTALL MOWER Be sure tractor is on level surface and engage parking brake. 1. Lower attachment lift lever to its lowest position. CAUTION: Lift lever is spring loaded. Have a tight grip on lift lever, lower it slowly and engage in lowest position. NOTE: Be sure mower side suspension arms (A) are pointing forward before sliding mower under tractor. 2. Slide mower under tractor until it is cen- tered under tractor. 03042tex 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
WARNING:
TO AVOID
SERIOUS
iNJURY,
BEFORE
PERFORMING
ANY
SERVICE
OR ADJUSTMENTS:
1.
Depress clutch/brake
pedal fully and set parking brake.
2.
Place gearshift
lever in neutral (N) position.
3.
Place attachment
clutch
in "DISENGAGED"
position.
4.
Turn ignition key to "STOP"
and remove
key.
5.
Make sure the blades and all moving parts have completely
stopped.
6.
Disconnect
spark plug wire from spark plug and place wire where
it cannot
come in contact
with plug.
TO REMOVE
MOWER
1.
Place
attachment
clutch
in
"DISEN-
GAGED"
position.
2.
Lower attachment
lift lever to its lowest
position.
3.
Roll belt off engine
pulley
(M) and belt
keepers
(G).
4.
Remove
retainer
spring (K), slide collar
(L) off and push housing
guide (P) out
of bracket.
5.
Remove
clutch
cable
spring
(Q) from
idler arm (R).
6.
Disconnect
front
link (E) from mower
-
remove
retainer spring and washer.
7.
Go to either side of mower
and discon-
nect
mower
suspension
arm
(A) from
chassis pin (B) and rear lift link (C) from
rear mower bracket (D) - remove retainer
springs and washers.
_f_
CAUTION:
After rear lift links are discon-
nected, the attachment
lift lever will be spring
loaded. Have a tight grip on lift lever when
changing position
of the lever.
8.
Slide mower out from under right side of
tractor.
IMPORTANT:
If an attachment
other than
the mower
is to be mounted
on the tractor,
remove
the front
link (E) and rear lift links
(C) from tractor
and hook the clutch spring
(Q) into the
cable
guide on front
edge
of
lower dash.
TO
iNSTALL
MOWER
Be sure tractor is on level surface and engage
parking brake.
1.
Lower attachment
lift lever to its lowest
position.
CAUTION:
Lift lever is spring
loaded.
Have a tight grip on lift lever, lower it slowly
and engage in lowest position.
NOTE:
Be sure
mower
side
suspension
arms (A) are pointing forward before sliding
mower
under tractor.
2.
Slide mower under tractor until it is cen-
tered under tractor.
03042tex
21