D-Link DCS-4701E User Manual - Page 12
Assembly and Installation, Step 4, If you are using PoE to power your camera
View all D-Link DCS-4701E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Section 2: Assembly and Installation Step 3 Connect the RJ-45 plug into the Ethernet connector, then screw the waterproof connector to the Ethernet connector by turning it about a half-turn clockwise. Step 4 Screw the back part of the waterproof connector clockwise until there is a tight seal around the Ethernet cable. If you are using PoE to power your camera, use the included rubber power connector plug to the power connector. D-Link DCS-4701E User Manual 12
12
D-Link DCS-4701E User Manual
Section 2: Assembly and Installation
Step 4
Screw the back part of the waterproof connector clockwise until there is a tight
seal around the Ethernet cable.
Step 3
Connect the RJ-45 plug into the Ethernet connector, then screw the waterproof
connector to the Ethernet connector by turning it about a half-turn clockwise.
If you are using PoE to power your camera,
use the included rubber power
connector plug to the power connector.