D-Link DG-104S Product Manual - Page 54

Command Line Interface

Get D-Link DG-104S PDF manuals and user guides View all D-Link DG-104S manuals
Add to My Manuals
Save this manual to your list of manuals

Page 54 highlights

Command Line Interface The DG-104S VoIP gateway offers a line-at-a-time prompt and response scheme to execute various configuration instructions. The interface displays a single prompt character ggdbg> when it is ready to accept a command (ex. ggdbg>set or ggdbg>show). Typing a question mark after the ggdbg> prompt will display a list of helpful user commands. Please note that all characters must be entered in lower case. All command line examples in this chapter are in bold type. Listed below are some of the most commonly used commands, parameter(s), and examples of their usage. General Setup Commands nwdbg system reboot Definition: This command is used to restart the device. Parameter(s): None. Example: nwdbg system reboot nwdbg save changes Definition: This command is used to save configuration changes into flash and restart the device. Parameter(s): None. Example: nwdbg save changes nwdbg factory reset Definition: This command is used to set the DG-104S back to its default settings and then restart the device. Parameter(s): None. Example: nwdbg factory reset 54

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
54
Command Line Interface
The DG-104S VoIP gateway offers a line-at-a-time prompt and response scheme
to execute various configuration instructions. The interface displays a single
prompt character
ggdbg>
when it is ready to accept a command (ex.
ggdbg>set
or
ggdbg>show
).
Typing a question mark after the
ggdbg>
prompt will display a list of helpful
user commands. Please note that all characters must be entered in lower case.
All command line examples in this chapter are in
bold
type.
Listed below are some of the most commonly used commands, parameter(s),
and examples of their usage.
General Setup Commands
nwdbg system reboot
Definition:
This command is used to restart the device.
Parameter(s):
None.
Example:
nwdbg system reboot
nwdbg save changes
Definition:
This command is used to save configuration changes
into flash and restart the device.
Parameter(s):
None.
Example:
nwdbg save changes
nwdbg factory reset
Definition:
This command is used to set the DG-104S back to its
default settings and then restart the device.
Parameter(s):
None.
Example:
nwdbg factory reset