Dell Force10 S25N-S50N FTOS Configuration Guide FTOS 8.4.2.7 E-Series TeraScal - Page 1131

VRRP Configuration By default, VRRP is not configured. The following list specifies the configuration tasks for VRRP: • Create a Virtual Router on page 1131 (mandatory) • Assign Virtual IP addresses on page 1132 (mandatory) • Set VRRP Group (Virtual Router) Priority on page 1135 (optional) • Configure VRRP Authentication on page 1136 (optional) • Disable Preempt on page 1137 (optional) • Change the Advertisement interval on page 1138 (optional) • Track an Interface or Object on page 1139 (optional) For a complete listing of all commands related to VRRP, refer to FTOS Command Line Interface. Create a Virtual Router To enable VRRP, you must create a Virtual Router on a physical or VLAN interface. In FTOS, a VRRP Group is identified by the Virtual Router Identifier (VRID). Starting in release 8.4.1.0, you can configure a VRRP group on an interface that belongs to a non-default VRF instance. Prerequisite: The interface on which you create the virtual interface must be enabled and configured with a primary IP address. To enable a Virtual Router, use the following command in the INTERFACE mode. To delete a VRRP group, use the no vrrp-group vrid command in the INTERFACE mode. Task Assign an interface (physical or VLAN) to an IPv4 or IPv6 VRRP group. Command Syntax Command Mode [vrrp-group vrid | vrrp-ipv6-group vrid] VRID range (C-Series and S-Series): 1-255 VRID range (E-Series): 1-255 when VRF microcode is not loaded and 1-15 when VRF microcode is loaded INTERFACE Figure 58-2. Command Example: vrrp-group FTOS(conf)#int gi 1/1 FTOS(conf-if-gi-1/1)#vrrp-group 111 FTOS(conf-if-gi-1/1-vrid-111)# Virtual Router ID and VRRP Group identifier Virtual Router Redundancy Protocol (VRRP) | 1131