Dell Force10 S25N-S50N FTOS Configuration Guide FTOS 8.4.2.7 E-Series TeraScal - Page 706

www.dell.com | support.dell.com Return to CONFIGURATION mode to enable the OSPF process. The OSPF Process ID is the identifying number assigned to the OSPF process, and the Router ID is the IP address associated with the OSPF process. . Command Syntax router ospf process-id [vrf {vrf name}] Command Mode CONFIGURATION Usage Enable the OSPFv2 process globally. Range: 0-65535 vrf name: Enter the VRF key word and instance name to tie the OSPF instance to the VRF. All network commands under this OSPF instance are subsequently tied to the VRF instance. Once the OSPF process and the VRF are tied together, the OSPF Process ID cannot be used again in the system. If you try to enter an OSPF Process ID, or if you try to enable more OSPF processes than available Layer 3 interfaces, prior to assigning an IP address to an interface and setting the no shutdown command, you will see the following message. Message 1 C300(conf)#router ospf 1 % Error: No router ID available. In CONFIGURATION ROUTER OSPF mode, assign the Router ID. The Router ID is not required to be the router's IP address. Dell Force10 recommends using the IP address as the Router ID for easier management and troubleshooting. Command Syntax router-id ip address Command Mode Usage CONFIG-ROUTER-O Assign the Router ID for the OSPFv2 SPF-id process. IP Address: A.B.C.D Use the no router ospf process-id command syntax in the CONFIGURATION mode to disable OSPF. Use the clear ip ospf process-id command syntax in EXEC Privilege mode to reset the OSPFv2 process. Use the show ip ospf process-id command in EXEC mode (Figure 408) to view the current OSPFv2 status. Figure 32-8. Command Example: show ip ospf process-id FTOS#show ip ospf 55555 Routing Process ospf 55555 with ID 10.10.10.10 Supports only single TOS (TOS0) routes SPF schedule delay 5 secs, Hold time between two SPFs 10 secs Number of area in this router is 0, normal 0 stub 0 nssa 0 FTOS# 706 | Open Shortest Path First (OSPFv2 and OSPFv3)