Dell Force10 S25N-S50N FTOS Configuration Guide FTOS 8.4.2.7 E-Series TeraScal - Page 1140

www.dell.com | support.dell.com To track an interface or configured object for a virtual group, use the track command in the VRRP mode: Task Monitor an interface or a configured object and, optionally, reconfigure the cost value to be subtracted from the VRRP group priority if the status of the tracked object goes DOWN. (Optional) Display the configuration and UP or DOWN state of tracked objects, including the client (VRRP group) that is tracking an object's state. (Optional) Display the configuration and UP or DOWN state of tracked interfaces and objects in VRRP groups, including the time since the last change in an object's state. (Optional) Display the configuration of tracked objects in VRRP groups on a specified interface. Command Syntax track {interface | object-id} [priority-cost cost] Valid object IDs are from 1 to 65535. Cost range: 1-254. Default: 10 show track show vrrp show running-config interface interface Command Mode INTERFACE-VRID EXEC EXEC Privilege EXEC EXEC Privilege EXEC EXEC Privilege Note: The sum of all the costs for all tracked interfaces and objects must be less than or equal to the configured priority of the VRRP group. Figure 58-14. Command Example: track interface FTOS(conf-if-gi-1/1)#vrrp-group 111 FTOS(conf-if-gi-1/1-vrid-111)#track gigabitethernet 1/2 FTOS(conf-if-gi-1/1-vrid-111)# Figure 58-15. Command Example: show configuration in VRID mode FTOS(conf-if-gi-1/1-vrid-111)#show configuration ! vrrp-group 111 advertise-interval 10 authentication-type simple 7 387a7f2df5969da4 no preempt priority 255 track GigabitEthernet 1/2 virtual-address 10.10.10.1 virtual-address 10.10.10.2 virtual-address 10.10.10.3 virtual-address 10.10.10.10 FTOS(conf-if-gi-1/1-vrid-111)# 1140 | Virtual Router Redundancy Protocol (VRRP)