Dell Force10 S25N-S50N FTOS Configuration Guide FTOS 8.4.2.7 E-Series TeraScal - Page 498

www.dell.com | support.dell.com Save the new CAM settings to the startup-config (write-mem or copy run start) then reload the system for the new settings to take effect. Command Syntax cam-acl {default | l2acl number ipv4acl number ipv6acl number, ipv4qos number l2qos number, l2pt number ipmacacl number ecfmacl number [vman-qos | vman-dual-qos number} Command Mode CONFIGURATION show cam-acl EXEC EXEC Privilege Purpose Allocate space for IPV6 ACLs. Enter the CAM profile name followed by the amount to be allotted. When not selecting the default option, you must enter all of the profiles listed and a range for each. The total space allocated must equal 13. The ipv6acl range must be a factor of 2. Show the current CAM settings. Assign an IPv6 Address to an Interface c e s IPv6 Addresses are supported on platforms Essentially IPv6 is enabled in FTOS simply by assigning IPv6 addresses to individual router interfaces. IPv6 and IPv4 can be used together on a system, but be sure to differentiate that usage carefully. Use the ipv6 address command to assign an IPv6 address to an interface. Command Syntax ipv6 address ipv6 address/ mask Command Mode Purpose CONFIG-INTERFACE Enter the IPv6 Address for the device. ipv6 address : x:x:x:x::x mask : prefix length 0-128 IPv6 addresses are normally written as eight groups of four hexadecimal digits, where each group is separated by a colon (:). Omitting zeros is accepted as described in Addressing earlier in this chapter. 498 | IPv6 Addressing