Dell Force10 S4810P Quick Start Guide - Page 17
Installing the Software, Navigating CLI Modes, Console Access
View all Dell Force10 S4810P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
2 Installing the Software Navigating CLI Modes The FTOS prompt changes to indicate the CLI mode. You must move linearly through the command modes, with the exception of the end command which takes you directly to EXEC Privilege mode; the exit command moves you up one command mode level. Console Access NOTE: Before starting this procedure, be sure you have a terminal emulation program already installed on your PC. The RS-232 console port is labeled on the S4810 chassis. It is in the upper righthand side, as you face the I/O side of the chassis. RJ-45 Console Port Step Task 1 Install an RJ-45 copper cable into the console port. Use a rollover cable to connect the S4810 console port to a terminal server. 2 Connect the other end of the cable to the DTE terminal server. 3 Default terminal settings on the console port are set as follows: 9600 baud rate No parity 8 data bits 1 stop bit No flow control Installing the Software 13