Dell Force10 S4810P Quick Start Guide - Page 23
Assign an IP address to a VLAN
View all Dell Force10 S4810P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Step Task Command Syntax 2 Configure an interface untagged interface as untagged. This command is available only in VLAN interfaces. Command Mode INTERFACE Assign an IP address to a VLAN VLANs are a Layer 2 feature. For two physical interfaces on different VLANs to communicate, you must assign an IP address to the VLANs to route traffic between the two interfaces. The shutdown command in INTERFACE mode does not affect Layer 2 traffic on the interface. NOTE: An IP address cannot be assigned to the Default VLAN, which, by default, is VLAN 1. To assign another VLAN ID to the Default VLAN, use the default vlan-id vlan-id command. Task Command Syntax Configure an IP address ip address ip-address mask and mask on the interface. [secondary] Command Mode INTERFACE Connecting the S4810 to the Network Once you have completed the hardware installation and software configuration for the S4810, you can connect to your company network by following your company's cabling requirements. Installing the Software 19