Dell Latitude ATG D620 Service Manual - Page 8

Internal Card with Bluetooth, Wireless Technology

Page 8 highlights

Back to Contents Page Internal Card with Bluetooth® Wireless Technology Dell™ Latitude™ D620 Service Manual CAUTION: Before performing the following procedures, follow the safety instructions in your Product Information Guide. NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of the computer. NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer. If you ordered an internal card with Bluetooth wireless technology with your computer, it is already installed. 1. Follow the procedures in Before You Begin. 2. Remove the hinge cover (see Hinge Cover). 3. Gently pull left on the cable for the card with Bluetooth wireless technology. 4. When there is enough clearance between the right edge of the card and the card holder, insert a plastic scribe and pry the card to the left until it is released from the metal clip. 1 metal tab 4 card cable 2 card 3 card connector NOTICE: Be careful when removing the card to avoid damaging the card, card cable, or surrounding components. 5. Disconnect the card from the cable and remove the card from the computer. Back to Contents Page

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43

Back to Contents Page
Internal Card with Bluetooth
®
Wireless Technology
Dell™ Latitude™ D620
Service Manual
If you ordered an internal card with Bluetooth wireless technology with your computer, it is already installed.
1.
Follow the procedures in
Before You Begin
.
2.
Remove the hinge cover (see
Hinge Cover
).
3.
Gently pull left on the cable for the card with Bluetooth wireless technology.
4.
When there is enough clearance between the right edge of the card and the card holder, insert a plastic scribe and pry the card to the left until it is
released from the metal clip.
5.
Disconnect the card from the cable and remove the card from the computer.
Back to Contents Page
CAUTION:
Before performing the following procedures, follow the safety instructions in your
Product Information Guide
.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of
the computer.
NOTICE:
To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.
1
metal tab
2
card
3
card connector
4
card cable
NOTICE:
Be careful when removing the card to avoid damaging the card, card cable, or surrounding components.