Dell Latitude ATG D620 Service Manual - Page 9

Coin-Cell Battery

Page 9 highlights

Back to Contents Page Coin-Cell Battery Dell™ Latitude™ D620 Service Manual CAUTION: Before performing the following procedures, follow the safety instructions in your Product Information Guide. NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of the computer. NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer. 1. Follow the procedures in Before You Begin. 2. Remove the hinge cover (see Hinge Cover). 3. Remove the keyboard (see Keyboard). 1 coin-cell battery connector 2 plastic mylar 3 coin-cell battery 4. Remove the coin-cell battery connector from the connector on the system board. 5. Being careful not to break the plastic, slightly raise the corner of the plastic mylar above the battery. 6. While holding the mylar, grasp the battery and pull out of the battery compartment. Back to Contents Page

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43

Back to Contents Page
Coin-Cell Battery
Dell™ Latitude™ D620
Service Manual
1.
Follow the procedures in
Before You Begin
.
2.
Remove the hinge cover (see
Hinge Cover
).
3.
Remove the keyboard (see
Keyboard
).
4.
Remove the coin-cell battery connector from the connector on the system board.
5.
Being careful not to break the plastic, slightly raise the corner of the plastic mylar above the battery.
6.
While holding the mylar, grasp the battery and pull out of the battery compartment.
Back to Contents Page
CAUTION:
Before performing the following procedures, follow the safety instructions in your
Product Information Guide
.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of
the computer.
NOTICE:
To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.
1
coin-cell battery connector
2
plastic mylar
3
coin-cell battery