Dell PowerConnect W-IAP Remote Configuration Guide - Page 1106

30 Displaying BGP4 information TABLE 184 BGP4 summary information (Continued) Field Description Filtered Sent ToSend The routes or prefixes that have been filtered out: • If soft reconfiguration is enabled, this field shows how many routes were filtered out (not placed in the BGP4 route table) but retained in memory. • If soft reconfiguration is not enabled, this field shows the number of BGP4 routes that have been filtered out. The number of BGP4 routes that the Layer 3 Switch has sent to the neighbor. The number of routes the Layer 3 Switch has queued to send to this neighbor. Displaying the active BGP4 configuration To view the active BGP4 configuration information contained in the running-config without displaying the entire running-config, use the following CLI method. To display the device active BGP4 configuration, enter the following command at any level of the CLI. PowerConnect#show ip bgp config Current BGP configuration: router bgp address-filter 1 deny any any as-path-filter 1 permit ^65001$ local-as 65002 maximum-paths 4 neighbor pg1 peer-group neighbor pg1 remote-as 65001 neighbor pg1 description "PowerConnect group 1" neighbor pg1 distribute-list out 1 neighbor 192.169.100.1 peer-group pg1 neighbor 192.169.101.1 peer-group pg1 neighbor 192.169.102.1 peer-group pg1 neighbor 192.169.201.1 remote-as 65101 neighbor 192.169.201.1 shutdown neighbor 192.169.220.3 remote-as 65432 network 1.1.1.0 255.255.255.0 network 2.2.2.0 255.255.255.0 redistribute connected Syntax: show ip bgp config Displaying CPU utilization statistics You can display CPU utilization statistics for BGP4 and other IP protocols. To display CPU utilization statistics for BGP4 for the previous one-second, one-minute, five-minute, and fifteen-minute intervals, enter the following command at any level of the CLI. 1064 PowerConnect B-Series FCX Configuration Guide 53-1002266-01