Dell PowerConnect W-IAP Remote Configuration Guide - Page 762

24 LLDP-MED attributes advertised by the Dell PowerConnect device PowerConnect#show lldp statistics Last neighbor change time: 23 hours 50 minutes 40 seconds ago Neighbor entries added : 14 Neighbor entries deleted : 5 Neighbor entries aged out : 4 Neighbor advertisements dropped : 0 Port 1 2 3 4 5 6 7 8 9 10 11 12 13 14 Tx Pkts Total 60963 0 60963 60963 0 0 0 0 0 60974 0 0 0 0 Rx Pkts Total 75179 0 60963 121925 0 0 0 0 0 0 0 0 0 0 Rx Pkts Rx Pkts Rx TLVs Rx TLVs Neighbors w/Errors Discarded Unrecognz Discarded Aged Out 0 0 0 0 4 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 Syntax: show lldp statistics NOTE You can reset LLDP statistics using the CLI command clear LLDP statistics. Refer to "Resetting LLDP statistics" on page 725. The following table describes the information displayed by the show lldp statistics command. This field... Displays... Last neighbor change time The elapsed time (in hours, minutes, and seconds) since a neighbor last advertised information. For example, the elapsed time since a neighbor was last added, deleted, or its advertised information changed. Neighbor entries added The number of new LLDP neighbors detected since the last reboot or since the last time the clear lldp statistics all command was issued. Neighbor entries deleted The number of LLDP neighbors deleted since the last reboot or since the last time the clear lldp statistics all command was issued. Neighbor entries aged out The number of LLDP neighbors dropped on all ports after the time-to-live expired. Note that LLDP entries age out naturally when a port cable or module is disconnected or when a port becomes disabled. However, if a disabled port is re-enabled, the system will delete the old LLDP entries. Neighbor advertisements dropped The number of valid LLDP neighbors the device detected, but could not add. This can occur, for example, when a new neighbor is detected and the device is already supporting the maximum number of neighbors possible. This can also occur when an LLDPDU is missing a mandatory TLV or is not formatted correctly. Port The local port number. Tx Pkts Total The number of LLDP packets the port transmitted. Rx Pkts Total The number of LLDP packets the port received. 720 PowerConnect B-Series FCX Configuration Guide 53-1002266-01