Dell PowerConnect W-IAP Remote Configuration Guide - Page 49

Using stack-unit, slot number, and port number with CLI commands 1 Displaying lines that do not contain a specified string The following command filters the output of the show who command so it displays only lines that do not contain the word "closed". This command can be used to display open connections to the Dell PowerConnect device. PowerConnect#show who | exclude closed Console connections: established you are connecting to this session 2 seconds in idle Telnet connections (inbound): 1 established, client ip address 192.168.9.37 27 seconds in idle Telnet connection (outbound): SSH connections: Syntax: | exclude Displaying lines starting with a specified string The following command filters the output of the show who command so it displays output starting with the first line that contains the word "SSH". This command can be used to display information about SSH connections to the Dell PowerConnect device. PowerConnect#show who | begin SSH SSH connections: 1 established, client ip address 192.168.9.210 7 seconds in idle 2 closed 3 closed 4 closed 5 closed Syntax: | begin Searching and filtering output at the --More-- prompt The --More-- prompt displays when output extends beyond a single page. From this prompt, you can press the Space bar to display the next page, the Return or Enter key to display the next line, or Ctrl+C or Q to cancel the display. In addition, you can search and filter output from this prompt. At the --More-- prompt, you can press the forward slash key ( / ) and then enter a search string. The Dell PowerConnect device displays output starting from the first line that contains the search string, similar to the begin option for show commands. An example is given below. PowerConnect B-Series FCX Configuration Guide 7 53-1002266-01