Dell PowerStore 9000X EMC PowerStore Network Planning Guide - Page 37
Step details, Notes
View all Dell PowerStore 9000X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Table 13. PowerStore T model Network Setup Preparation Worksheet (example) (continued) Step Step details Notes VLT MAC address to use for both switch 1 and switch 2. 00:00:00:00:00:01 Use the same VLT MAC address for switch 1 and switch 2. NOTE: You cannot use all zeros (00:00:00:00:00) for the VLT MAC address. VLT priority for switch 1 1 VLT priority for switch 2 8192 13. If configuring with Link Aggregation Control Protocol (LACP) record the LACP (port channel) ID for the node connections: Port Channel ID for Node A port channel 10 Port Channel ID for Node B port channel 20 14. Record the ports on the ToR switches that will be used to connect to the uplinks. Uplink A to ToR 1 port 29 Uplink B to ToR 1 port 30 Uplink A to ToR 2 port 29 Uplink B to ToR 2 port 30 15. Record the port channel ID using for connectivity between the ToR switches and the uplinks. If deploying with MC-LAG, enter the port channel ID used port channel 30 for the uplink. Only a single port channel ID is required for MC-LAG. Alternatively, record the uplink port channel IDs required for Reliable L2. Reliable L2 connectivity requires two port channel IDs. 1. Port channel ID for Reliable L2 N/A 2. Port channel ID for Reliable L2 N/A 16. As a best practice it is recommended to add a spanning tree protocol to the ToR switches. Record the spanning tree protocols to set on each switch. Spanning tree protocol for ToR switch 1 40960 Spanning tree protocol for ToR switch 2 45056 17 Record the port channel ID for the OOB management switch. port channel 10 18. Once you have completed steps above, you have the necessary information to configure the switches. Continue to work with your network administrator to complete the Initial Configuration Worksheet now to ensure that: ● Your network configuration on the switch aligns with the network configuration that will be done in PowerStore T model. ● You reserve the necessary network resources to complete deployment of PowerStore T model and the PowerStore T model networks. 19. Determine if you will use a direct connection or a remote connection to discover your PowerStore. Once you have successfully discovered your PowerStore, you will be guided through the Initial Configuration Wizard to create your first PowerStore cluster. PowerStore Network Setup Preparation Worksheets 37