Denon AVR 1609 Owners Manual - English - Page 27

Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting Specifications ENGLISH Test Tone Start Press o to select "Yes", then press o p to select "Auto" or "Manual". Then press i. Out put the test tone. Auto : Press o p to adjust the volume. Manual : Press u i to select the speaker, then press o p to adjust the volume. When the adjustments are completed, press ENTER to finish the test tone. [Variable range] -12dB ~ 0dB ~ +12dB Operating from the remote control unit Adjusting with the remote control unit using the test tones is only possible in the "Auto" mode and only effective in the STANDARD mode. The adjusted levels for the different modes are automatically stored in the memory. GAdjusting using test tonesH q Press [TEST]. Test tones are output from the various speakers. w Use o p to adjust so that the volume is equal for all speakers. e When the adjustments are completed, press [TEST]. • When "System Setup" - "Speaker Setup" - "Surround Back Speaker" setting (vpage 22) is set to "1spkr", the surround back speaker display is "SB". • Speakers set to "None" in the Speaker Configuration settings are not displayed. • When "Channel Level" is adjusted, the adjusted values are set for all the surround modes. S3 Restore After the Auto Setup measurements, it is possible to return those settings to the Auto Setup measurement results after changing the speaker settings (speaker configuration, distance, channel level and crossover frequency) with "System Setup" - "Speaker Setup". Press o to start. [Display] 1.Sp 2.In 3.Op Q Speaker Setup 23 Restore Yes< It is not possible to return to Amp Assign settings with Restore. After running Auto Setup, if the Amp Assign setting has changed, return to the setting when Auto Setup was run. 2. Input Setup Use this procedure to select the input source and make the settings related to playing input sources. a , s HDMI In Assign d ~ h Digital In Assign j iPod Assign k Audio Delay l EXT. IN Subwoofer Level A0 Auto Preset Memory A1 Parental Lock A2 Edit Lock Code a , s HDMI In Assign Select HDMI connector to assign to this source. [Display] 1.Sp 2.In 3.Op W Input Setup W 1 HDMI1:DVD W 2 HDMI2:TV [Input terminals] HDMI1 HDMI2 [Assignable input sources] DVD/HDP z1 TV/CBL z2 VCR V.AUX OFF z1 : "DVD" is displayed. z2 : "TV" is displayed. Input terminals Default setting a HDMI1 DVD/HDP s HDMI2 TV/CBL • With HDMI, the video and audio signals are transferred simultaneously. (The HDMI audio signal is output from the monitor.) At this time, set the input mode to "Auto". • The audio signals input from the analog, digital and EXT. IN connectors are not output to the monitor. For details on how to select, set and cancel settings for each menu, see "System setup operation" (vpage 21). 24