Denon AVR 1609 Owners Manual - English - Page 44

Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting Specifications ENGLISH Symbols used to indicate buttons in this manual Button located on both the main unit and the remote control unit BUTTON Button only on the main unit Button only on the remote control unit [BUTTON] [Front] [OFF] [iPod] [2] [1] [6], [7] [8], [9] [ENTER] [uip] [Rear] [iPod] [TUNING + -] [ENTER] [uip] [MODE] iPod® Playback The music on an iPod can be played by using the control dock for iPod (ASD-1R, ASD-11R, ASD-3N or ASD-3W, sold separately). The operation can also be performed using the buttons on the remote control unit. iPod is a trademark of Apple Inc., registered in the U.S. and other countries. b The iPod may only be used to copy or play contents that are not copyrighted or contents for which copying or playback is legally permitted for your private use as an individual. Be sure to comply with applicable copyright legislation. Preparations 1 Make the necessary preparations. qSet the iPod in the DENON control dock for iPod. (vSee the control dock for iPod's operating instructions.) wAssign the control dock for iPod's input. The input for the control dock for iPod is assigned to VCR by default. "System Setup" - "Input Setup" - "iPod Assign" (vpage 25) 2 Either turn or press [iPod] to select the input source assigned in step 1-w above. 3 Set [SOURCE CONTROL 1] to "AUDIO" and [SOURCE CONTROL 2] to "iPod/NETWORK". (v page 45 "Remote Control Unit Operations") 4 Press [MODE] and hold it down for a 2 seconds or more to select the display mode. To switch between modes, press and hold down the button. When remote mode is active, "Remote" is displayed. [Selectable mode] Browse mode Remote mode Display location Main unit display iPod display Playable files Audio file Video file S S z1 S S z2 Remote Active control unit S S buttons (AVR-1609) iPod A S z1 : When using an ASD-3N or ASD-3W control dock for iPod. z2 : Video may not be output, depending on the combination of ASD-1R or ASD-11R and iPod. • With the default settings, the iPod can be used connected to the VCR (iPod) connector. • Use the RESTORER mode to expand the low and high frequency components of compressed audio files and achieve a richer sound. The default setting is "Mode3" (vpage 35). • Press or [OFF] and set the AVR-1609's power to the standby mode before disconnecting the iPod. Also switch the input source to one to which "iPod Assign" is not assigned before disconnecting the iPod. • When using an ASD-3N or ASD-3W control dock for iPod, refer to the respective manual to operate. [SOURCE CONTROL 1] [SOURCE CONTROL 2]