Denon AVR 1609 Owners Manual - English - Page 62

Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting Specifications ENGLISH GRemote Control UnitH Symptom Set does not work properly when remote control unit operated. Cause • Batteries are worn. • You are operating outside of the specified range. • Obstacle between main unit and remote control unit. • The batteries are not inserted in the proper direction, as indicated by the polarity marks in the battery compartment. • The set's remote control sensor is exposed to strong light (direct sunlight, inverter type fluorescent bulb light, etc.). • The remote ID of the main unit and remote control unit do not match. • The SOURCE CONTROL switches are not set in the correct positions. Countermeasure • Replace with new batteries. • Operate within the specified range. • Remove the obstacle. • Insert the batteries in the proper direction, following the polarity marks in the battery compartment. • Move the set to a place in which the remote control sensor will not be exposed to strong light. • Set "Remote ID" for the main unit to "1". • Set the SOURCE CONTROL switches to the correct positions according the operation you are applying. Page 3 3 3 3 3 28 38, 40, 41, 45 ~ 47, 50 GAudioH Symptom Cause Countermeasure No sound is • You are playing a monaural • The mode is set to something produced from source (TV, AM radio broadcast, other than "STANDARD" (Dolby/ center speaker. etc.) in the "STANDARD" (Dolby/ DTS Surround). DTS Surround) mode. No sound • The surround mode is set to • Set to a surround playback is produced "STEREO" or "DIRECT". mode. from surround speakers. No sound is • Select item other than "7.1ch" by • Select "7.1ch". produced from "Amp Assign" setting. surround back • Surround back speaker setting is • Set to something other than speaker. set to "None". "None". • The "Parameter" - "Surround • Please set "Parameter" - Parameter" - "SB CH OUT" "Surround Parameter" - "SB settings are "OFF". CH OUT" to settings other than "OFF". • Surround mode not set to a mode • Select a surround playback for 6.1- or 7.1-channel playback. mode. No sound is • Subwoofer's power not turned • Turn on the subwoofer's power. produced from on. subwoofer. • The "Subwoofer" setting at • Set to "Yes". "Speaker Setup" is set to "No". • The subwoofer is not properly • Check the connections. connected. • The subwoofer's volume is • Adjust the subwoofer's volume turned off. to an appropriate level. No test tones are • Surround mode not set to • Set to the "STANDARD"(Dolby/ produced when " S TA N D A R D " ( D o l b y / D T S DTS Surround) mode. remote control Surround). unit's TEST button is pressed. DTS sound is not • DVD player's audio output setting • Set the DVD player. For details, output. is not set to bitstream. refer to the DVD player's operating instructions. • DVD player is not compatible • Use a DTS-compatible player. with DTS sound playback. • The AVR-1609's "Input Mode" • Set to the "Auto" or "DTS" setting is set to other than mode. "DTS". Page 29 30 27 22 33 29, 30 - 22 9 43 29 - - 37 59