Denon DN-A7100 User Guide - Page 34
Other Function
UPC - 081757507554
View all Denon DN-A7100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
ENGLISH OTHER FUNCTION ATTENUATION TO ANALOG INPUT SIGNAL TV AUTO ON/OFF FUNCTION This function allows the component connected to the TV-VIDEO in jack to control the power (ON/OFF) to the DN-A7100. VIDEO ON/OFF When no video signal is connected to the DN-A7100 or a DVD, etc., is connected directly to your TV, the unnecessary video circuit can be turned off by selecting the "VIDEO OFF" setting. To select video off, press the AMP button and press the V-OFF button. SELECTING ANALOG AUDIO INPUT OR DIGITAL AUDIO INPUT AUTO POWER ON 1. Be sure the TV auto mode is ENABLED. (Refer page 22 : System Setup) 2. Connect your TV TUNER (etc) to the TV- VIDEO in terminal. Be sure to connect the VIDEO input. 3. Turn OFF the power to the TV TUNER and the DN-A7100. 4. Turn ON the TV TUNER and tune in a receivable station. 5. When the station is received, the DN-A7100 turns ON and TV is selected automatically. AUTO POWER OFF 1. In the above situation, turn the TV TUNER OFF or select a channel that does not contain any broadcast. 2. The power to the DN-A7100 switches to STANDBY after approx. 5 minutes. Notes: • AUTO POWER OFF is canceled if the DN-A7100 is set to a source other than TV. The function reactivates when TV is selected again. • Some TV broadcasts may cause the TV AUTO FUNCTION to turn ON. • The S-Video terminal does not support "TV AUTO ON/OFF" function. If the selected analog audio input signal is greater than the capable level of internal processing, the "PEAK" indicator will light up on the front display. If this happens, you should press the ATT button on the remote. "ATT" indicator will be illuminated when this function is activated. The signal-input level is reduced by about half. Attenuation will not work with the output signal of TAPE-OUT, CD-R/MD-OUT and VCROUT. This function is memorized for each individual input source. LISTENING THROUGH HEADPHONES This jack may be used to listen to the DN-A7100's output through a pair of headphones. Be certain that the headphones have a standard 1/4" stereo phono plug. DISPLAY MODE You can select the display mode for the front display of the DN-A7100. To select this mode, press the DISPLAY on the remote control. When this button is pressed, the display mode is switched in the following sequence. → Surround Mode → Auto-display Off → Display Off → Input Function → Surround Mode.... In Auto display off mode, the display is off. But, if you make a change to the unit such as input or surround mode, the display will show that change, then go back to off after about 3 seconds. When changing the volume, it is not displayed. In Display off mode, the display is off completely. Note: Only the DISP indicator will be illuminated on the front display in display off condition If you have already assigned the digital inputs, you can temporarily select the audio input mode for each input source as following procedures. Press the AMP button and press the A/D button. When this button is pressed, the input mode is switched in the following sequence. → HDMI Auto → HDMI → Digital Auto → Digital → Analog → HDMI Auto.... In HDMI Auto mode, the types of signals being input to the digital and analog input jacks for the selected input source are detected automatically. If no digital signal is being input, the analog input jacks are selected automatically. In Digital and HDMI mode, input is fixed to an assigned digital input terminal. In analog mode, the analog input jacks are selected. This selecting is temporary, so the result will not be stored in memory. If you need to change the input mode completely, use INPUT SETUP in OSD menu system. (see page 20) 30