Denon DN-C640 Operating Instructions - Page 33

ENGLISH 3. DEVICE OPERATION 16. Auto sleep mode (Auto Sleep) You can select the behavior that the servo functions will automatically turn off if no operation is performed for set-up time while in stop, pause or cue. When in the sleep mode, if the PLAY/PAUSE button is pressed, playback will be started from the beginning of the track in which the sleep mode was set. If the CUE button is pressed, it will standby for the beginning of the track in which the auto sleep was set. Set value Off 30sec 10min 20min 30min(default) Unit never goes into sleep mode Processing Unit will goes into sleep mode if no servo functions occur for longer than the userdesignated time 17. Eject lock mode (Eject Lock) This feature allows you to prohibit ejecting a disc during playback Set value On (default) Off Processing Unit will not allow anyone to eject a disc while in the Play Mode Unit will allow a disc to be ejected while in the Play Mode 18. Digital output format (Digital Out) This allows you to designate the Digital Output format that is sent to both the balanced and unbalanced digital output terminals. Set value Broadcast (default) Consumer Processing Unit outputs AES/EBU formatted digital audio signal to both the balanced DIGITAL OUTPUT jack and the unbalanced DIGITAL OUTPUT jack Unit outputs S/PDIF formatted digital audio signal to both the balanced DIGITAL OUTPUT jack and the unbalanced DIGITAL OUTPUT jack 19. Digital FS (Digital FS) This feature allows you to set the sampling frequency of the digital audio signal that is sent out the DIGITAL AUDIO outputs. Set value Auto (default) 32kHz 44.1kHz 48kHz 16 kHz - 32 kHz 44.1 kHz 48 kHz Digital audio signal is outputted with below FS FS of the source audio signal 22.05 kHz 24 kHz 32 kHz 44.1 kHz - - 32 kHz 44.1 kHz 32 kHz 32 kHz 32 kHz 32 kHz 44.1 kHz 44.1 kHz 44.1 kHz 44.1 kHz 48 kHz 48 kHz 48 kHz 48 kHz 48 kHz 48 kHz 32 kHz 44.1 kHz 48 kHz 20. Time Zone (Time Zone) This feature allows you to select the Time zone. This setting is necessary to display the time correctly. Value of the Time Zone should represent the differences between the UTC(GMT) and your local time. NOTE: • Turn the power off and on again to make the new settings effective. Items 21-26 refer to the network operation of the unit. See page 34. 21. Machine name (Machine Name) 22. IP Address setting (IP Address) 23. Subnet mask setting (Subnet Mask) 24. Default Gateway setting (Gateway) 25. DNS server setting (DNS Server) 26. Network-Access Password setting (Password) 27. Default (Default) Setting this feature allows you to reset all of the unit's preset items to their default values. 25