Denon DRW-585 Operating Instructions - Page 10
a-8888:1-8898
View all Denon DRW-585 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
ENGLISH RECORDING (DECK B only) • Switch on your amplifier or receiver and the source component • Set the Tape Monitor switch on your amplifier or receiver to the SOURCE position. CD 0 DENON DRW,85 PPE.PKIIIAPVOCOPPPOMENT/OOPPL E PAYE PIP Of CP O1 1 O ,4(TO REVERSE D A MAY 21 a-8888:1-8898n P AP • = iTrA C=I C=I • FP VE11,1 D far/NAY B 1 O Press the POWER switch to the ON ) position. O Load the cassette tape. (Check that the erasure prevention tabs of the cassette housing have not been broken off.) CD Move the DOLBY NR switch and select the Dolby NR type that suits the recording. DOLBY NR 8 OFF C -1 • V -- ( O Press the Direction (4 Pr) button to select the direction of tape transport. 0 Select the type of tape transport with the REVERSE MODE switch. Mode Switch position To record on only one side ...__ To continuously record on both sides (7„,_,) or RELAY O Press the REC/REC MUTE ( • button to set the recording pause mode. The •II indicator will light up. O Adjust the recording level with the INPUT LEVEL control while watching the Peak Level Meter ® Press the PLAY button to start the recording. The PLAY (.1 or I>) and the • indicator will light during recording. C) To pause the recording, press the REC PAUSE ( II I button. Press the PLAY button to resume recording. ® To stop recording, press the stop ( • ) button Caution: • Be careful not to erase important recordings by mistake. Inadvertent start of recording will happen in the following cases: 1. If the PLAY button is pressed while the • indicator lights, recording starts. 2. If the PLAY and REC/REC MUTE I.) button are pressed at the same time, recording starts. The best way to avoid accidental erasure is to break off the two erasure prevention tabs on the cassette housing. 10