Denon DRW-585 Operating Instructions - Page 11
Proper, Recording, Level, Adjustment, Rec/rec, Pause, Button, Dimmer
View all Denon DRW-585 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
ENGLISH ■ PROPER RECORDING LEVEL A too high recording level can saturate the tape and cause distortion On the other hand, if the recording level is set too low, soh passages wi l l be marked by residual noise. A proper recording level is the single most important factor for making well balanced recordings Guideline for maximum recording level TYPE I (Normal) TYPE II (CrO2 ) TYPE IV (Metal) 0 dB level on peaks 11 dB level on peaks i3 dB level on peaks Note: The optimum recording level differs depending on the program source and the type of tape used OUTPUT LEVEL (dB) If the high frequencies (treble sounds) are to be boosted, turn the BIAS FINE control counter -clockwise to decrease the bias current Turn the control clockwise to increase bias current. By the use of this control, you can record tapes with a frequency response that wil l perfectly match your listening taste Counterclockwise Clockwise FREQUENCY (Hz) ■ RECORDING BIAS ADJUSTMENT For best recording results, monitoring during recording and comparing different recordings using your own judgement are essential . The DENON cassette deck is equipped with a BIAS FINE control to assist you in setting the proper bias for different types and brands of tape. At the center stop-click position, the deck is set to the reference bias level for Normal, CrO, and Metal tape. If the resulting recording in this position has too much or too little high frequency content, adjusting the BIAS FINE control can be useful to achieve better results. BIAS FINE 0 ■ REC/REC MUTE AND REC PAUSE Button 1 To record a 5-second blank section during recording: Press the REC/REC MUTE (•) button. A 5-second blank will be recorded and the deck will enter the recording standby mode. 2. To record a 5-second blank section during the recording standby mode: Press the REC/REC MUTE ( • ) button from the recording standby mode. A 5 second blank will be recorded and the deck will enter the recording standby mode again 3 To cancel recording of blank space: Press the REC PAUSE (II) button. Blank space recording will be cancelled and the deck enters the recording standby mode. 4 To extend the blank section with another 5 seconds or more: Simply press the REC/REC MUTE (• ) button and the blank section will be increased with another 5 seconds. ■ DIMMER ADJUSTMENT With the DRW-585, the brightness of the display can be adjusted in seven steps. To make the display brighter, press the B deck's fast forward ( button while holding in the B deck's STOP button. To make the display dimmer, press the fast rewind ( *4 ) button while holding in the STOP button. The display is initially set to the maximum brightness. 11