Dewalt D55167 Instruction Manual - Page 18
POSSIBLE CAUSE, POSSIBLE SOLUTION, Extension, Cords, Risk of Explosion or Fire, Air Filter - lowes
View all Dewalt D55167 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
English Code 15 16 possible cause Tank pressure exceeds pressure switch cut-in pressure Extension cord is wrong length or gauge 17 Loose electrical connections 18 Possible defective motor 19 Paint spray on internal motor parts 20 Fuse blown, circuit breaker tripped 21 Worn Belt 22 Restricted air intake filter POSSIBLE SOLUTION Motor will start automatically when tank pressure drops below cutin pressure of pressure switch. Check for proper gauge wire and cord length refer to the Extension Cords under Installation. Check wiring connection inside pressure switch and terminal box area. Contact a DeWALT factory service center or a DeWALT authorized service center. Contact a DeWALT factory service center or a DeWALT authorized service center. Do not operate the compressor in the paint spray area. See Risk of Explosion or Fire warning under Important Safety Instructions. 1. Check fuse box for blown fuse and replace as necessary. Reset circuit breaker. Do not use a fuse or circuit breaker with higher rating than that specified for our particular branch circuit. 2. Check for proper fuse. You should use a time delay fuse. 3. Check for low voltage conditions and/or proper extension cord. 4. Disconnect the other electrical appliances from circuit or operate the compressor on its own branch circuit. Contact a DeWALT factory service center or a DeWALT authorized service center. Clean or replace air intake filter. Do not operate the air compressor with the filter removed. Refer to the Air Filter paragraph in the Maintenance section. 18