Dewalt DCS371P1 Instruction Manual - Page 15
Installing the Brush, Brush Cap and Blade, Guards Fig. 8
View all Dewalt DCS371P1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
English FIG 6 FIG. 7 1. Turn the saw over and place it on a workbench or table with the handle to the right. 2. First, slide the brush (T) into the slot as seen in Figure 8, then place the brush cap (U) over top and screw securely into place. 3. Install the blade guards (V) by aligning them as shown and attach them with the hex wrench (E, Fig. 2) using the screws supplied. Make sure they are securely attached. FIG. 8 U T F Installing the Brush, Brush Cap and Blade Guards (Fig. 8) WARNING: To reduce the risk of serious personal injury, turn tool off and remove the battery pack before making any V V adjustments or removing/installing attachments or accessories. An accidental start-up can cause injury. WARNING: To reduce the risk of serious personal injury, the brush, brush cap and blade guard assembly must be installed for one-handed use. NOTE: It is available at extra cost from your local dealer or authorized service center. This assembly (brush, brush cap and blade guards) is not compatible with the Type 1 DCS371 band saw. 13