Dynex DX-CRMN1 User Guide - Page 9
Troubleshooting - mac
UPC - 600603113499
View all Dynex DX-CRMN1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Troubleshooting 9 Troubleshooting If memory cards do not appear in My Computer/Computer or Windows Explorer (Windows operating systems) or on the desktop (Mac operating systems), check the following: • Make sure that the memory card is fully inserted into the slot. • Make sure the card reader is fully connected to your computer. Unplug and reconnect your card reader. • Try a different memory card of the same type in the same slot. If a different memory card works, the original memory card should be replaced. • Disconnect the cable from your card reader and shine a flashlight into the empty card slots. Look to see if any pin inside is bent, then straighten bent pins with the tip of a mechanical pencil. Replace your memory card reader if a pin has bent so much that it touches another pin. If memory cards appear in My Computer/Computer (Windows operating systems) or on the desktop (Mac operating systems) but errors occur when writing or reading, check the following: • Make sure that the memory card is fully inserted into the slot. • Try a different memory card of the same type in the same slot. If the different memory card works, the original memory card should be replaced. • Some cards have a read/write security switch. Make sure that the security switch is set to Write Enabled. • Make sure that the amount of data you attempted to store has not exceeded the capacity of the card. • Inspect the ends of the memory cards for dirt or material closing a hole. Clean the contacts with a lint-free cloth and small amounts of isopropyl alcohol. • If errors persist, replace the memory card.