EMC AX100i Release Notes - Page 40

Installation Performing a silent installation 1. On another attached Windows server (not the same server on which you created the response file), enter one of the commands below to install the initialization utility. Setup.exe -s -f1fullpath\responsefilename -f2fullpath\logfilename where -s Indicates a silent installation. A silent installation requires no input after you enter the command. -f1fullpath\responsefilename Specifies the full pathname of the Initialization Utility response file you created. -f2fullpath\logfilename Specifies the full pathname and filename of the log file. We recommend that you create the log file on a local directory so you do not override a log file from another server's installation. 2. Verify that the installation was successful ("Verifying the silent installation or removal" on page 48) before running the command on all remaining attached Windows servers. 3. If the installation was successful, repeat step 1 on all remaining attached Windows servers. Removing the Navisphere Initialization Utility To perform a silent removal of the Navisphere Storage System Initialization Utility, all servers must be running the same revision of the utility. If you have different revisions installed on a Windows server, you cannot perform a silent removal. Important We do not recommend that you remove the Navisphere Storage System Initialization Utility using the command line interface unless you are an advanced user. To perform a silent removal for the Initialization Utility follow the procedure below. 40 EMC AX100-Series Integrated Management Software Release Notes