EVGA 122-CK-NF63-TR User Manual - Page 76
Fan Connections
View all EVGA 122-CK-NF63-TR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Hardware Installation Fan Connections There are two fan connections, the system fan and the CPU fan. The fan speed can be detected and viewed in the PC Health Status section of the CMOS Setup. Both fans are automatically turned off after the system enters S3, S4 and S5 mode. Note that the CPU fan cable can be either a 3-pin or a 4-pin connector. Connect a 3-pin connector to pins 1, 2, and 3 on the motherboard connector. CPU Fan Connector 4 3 21 GND SENSE PWR CONTROL The nForce SPP and MCP have a passive heat sink that draws heat from the chips. You can install a fan onto the SPP heat sink that helps to cool the chips. Hook the fan over the SPP heat sink. Use the two screws to secure the fan to the SPP. Plug the cable into the fan connector. SPP Connector 3 21 GND +12V SENSE Secure fan assembly using two screws 25