Electrolux EIDW5705PS Complete Owner's Guide (English) - Page 17
Dishwasher Leaks, Normal, Sounds You Will, Water In The Bottom Of, The Tub, Dishwasher Won't Run,
View all Electrolux EIDW5705PS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Solutions to Common Problems 17 DISHWASHER LEAKS DISHWASHER WON'T RUN • Use only fresh detergent designed for automatic dishwashers. Measure detergent carefully. Try a different brand. • Spilled rinse aid can cause foam and lead to overflowing. Wipe up any spills with a damp cloth. • Check to see that dishwasher is level (See Installation Instructions). NORMAL SOUNDS YOU WILL HEAR • Normal sounds include water fill, water circulation and motor sounds. • Pump pulsing will cause motor speed to increase and decrease at regular intervals during cycles. WATER IN THE BOTTOM OF THE TUB • Check to see if circuit breaker is tripped or if a fuse is blown. • Make sure water supply is turned on. • Check to see if cycle is set correctly. (See Operating Instructions) • Check to see if the DELAY START option has been selected. • Make sure door is closed and latched. • Check to see if dishwasher is in the Child Lock cycle. DISHWASHER DOES NOT DRAIN PROPERLY • If unit is hooked up to a garbage disposal, make sure the disposer is empty. • If unit is hooked up to a new food waste disposer, check to see if the "knockout" plug located inside the disposal inlet has been removed. • Check to see if drain hose is kinked. • Make sure cycle is complete, not in a pause. • It is not normal for water to remain in the bottom of the tub at the end of a cycle. If water remains in the bottom of the tub at the end of a cycle, the dishwasher may not be draining properly. (See Dishwasher Does Not Drain Properly). The filter may also need to be cleaned. (See Care of Filter) Note: It is normal to see a small amount of water under the filter at the end of a cycle. CYCLE TAKES A LONG TIME • Check to see if cycle is in a water heating delay. • Check to see if the delay start option has been selected. • Check to see if the sanitize option has been selected.