Electrolux ELFW7537AT Complete Owners Guide English - Page 15

15 INSTALLATION 6. Tighten by hand until snug. Then tighten each supply connection another 2/3 turn with pliers. Do not bend, kink or pinch water inlet hoses. 7. Turn on the water and check for leaks.  NOTE The standpipe inside diameter must be 1-1/4" (3.2 cm) minimum. There must be an air gap around the drain hose in the standpipe. A snug hose fit can cause a siphoning action. Completing the installation 1. Plug the power cord into a grounded outlet. Connecting the drain 1. Verify the antisiphon disc is in place. Anti-Siphon Disc 2. Form a "U" shape on the end of the drain hose with the hose pointed toward the drain. Place the formed end in a laundry tub or a standpipe and secure the drain hose with the cable tie (provided in the manual bag) to the standpipe, inlet hose, laundry tub, etc. so the hose does not pull out from the force of the water. Insert Less Than 8.5" (21.5 cm) Cable Tie WARNING ELECTRICAL SHOCK HAZARD Improper connection of the equipment grounding conductor can result in a risk of electrical shock. Check with a licensed electrician if you are in doubt as to whether the appliance is properly grounded. 2. Turn on the power at a circuit breaker/ fuse box. 3. Carefully slide the washer to its final position. Recheck for level and rock corners for stability. See Leveling the washer. Remove and discard door tape. 4. Run the washer through a complete cycle, checking for water leaks and proper operation. 5. If you have any questions during initial operation, please review the Troubleshooting section before calling for service. 6. Place these instructions in a location near the washer for future reference. IMPORTANT Check to ensure the power is off at a circuit breaker/fuse box before plugging the power cord into an outlet.  NOTE A wiring diagram and technical data sheet are located under the washer top panel, on top of the detergent dispenser housing.