Epson 2180 User Manual - Page 129
Changing default settings, Roll paper
UPC - 010343815766
View all Epson 2180 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
Roll paper When you turn on this mode, the printer recognizes that the paper is not single sheets, so it does not try to eject the paper and advance it forward to the next page when you press the LF/FF button. Changing default settings Follow the steps below to enter the default-setting mode and change the printer's default settings. Note: t To print the language selection and default-setting mode 5 instructions, you need three sheets of A4- or letter-size single-sheet paper or three pages of continuous paper that is at least 279 mm (11 inches) long and 210 mm (8.27 inches) wide. See Chapter 2 for instructions on loading continuous paper, or Chapter 3 for instructions on loading single sheets. t If you use single sheets, you need to load a new sheet of paper each time the printer ejects a printed sheet. 1. Make sure paper is loaded and the printer is turned off. c Caution: Whenever you turn off the printer, wait at least five seconds before turning it back on; otherwise you may damage the printer. 2. Hold down the Pitch button while you press the Operate button to turn on the printer. The printer enters the defaultsetting mode and prints the language selection instructions (one page). 3. Press the Pitch button until the Pitch lights indicate the language you want, as described in the language selection instructions. Changing Printer Settings From the Printer's Control Panel 5-9