Epson BrightLink 710Ui Installation Guide - Ultra-Short Throw Wall Mount ELPMB - Page 14
Installation worksheet for projecting on a pre-installed wall-mounted, board, Touch Unit.
View all Epson BrightLink 710Ui manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Installation worksheet for projecting on a pre-installed wall-mounted board 10 in. (254 mm)-height of wall plate plus cover Required distance from top of image area to bottom holes of wall plate (c) 1.0 to 4.0 in. (25 to 100 mm)- distance from top of image area to bottom of Touch Unit (if applicable) Height of image area (h) Diagonal size of image area (S) Distance from top of image area to temporary wall plate hole (d) 4.7 in. (120 mm)- minimum distance from top of image area to top of board (Touch Unit only) 4.0 in. (100 mm)- minimum distance from edge of image area to edge of board 0.8 in. (20 mm)- minimum distance from bottom of image area to bottom of board Width of image area (w) Distance from floor to bottom of image area (f) If you want to install the Touch Unit outside of the frame of a whiteboard, use the included Touch Unit Bracket. If the distance from the wall to the surface of the whiteboard is greater than 2 inches (51 mm) or the frame of the whiteboard extends more than 0.1 inch (3 mm) away from the board surface, you must install the Touch Unit on the whiteboard or screen. See the documentation included with your projector for details on mounting the Touch Unit. 1. Measure the ceiling height (distance from the floor to the ceiling). _____ 2. Measure the height of the board's image area (h). _____ (h) 3. Measure the width of the board's image area (w). _____ (w) 4. Measure the distance from the floor to the bottom of the board's image area (f ). _____ (f ) 5. Measure the thickness of the board (distance from the projection surface to the wall) _____ (x) (x). 6. Determine the aspect ratio of the board or of the images that will be projected. For new computers or laptops, this will most likely be WXGA or WUXGA (16:10). For older equipment, this will most likely be XGA (4:3). You may need to consult your IT department for this information. ___ 4:3 XGA ___ 16:10 WXGA/WUXGA ___ 16:9 Widescreen If your desired aspect ratio does not match the native aspect ratio of your product, use the Throw Distance Calculator at www.epson.com/support (U.S.), www.epson.ca/support (Canada), or www.epson.com.jm (Latin America) to determine the correct measurements. 14