Epson BrightLink 710Ui Installation Guide - Ultra-Short Throw Wall Mount ELPMB - Page 23
Installing the Projector, Assemble the parts
View all Epson BrightLink 710Ui manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
English 5 Installing the Projector Make sure to follow the steps below to install the wall mount. If you ignore these steps, the wall mount could fall and cause personal injury or property damage. Warning ❏ When you mount the projector on the wall with the wall mount, the wall requires enough strength to hold the projector and the wall mount, as well as the Control Pad and the Touch Unit, if applicable. This wall mount should be installed on a concrete wall. Confirm the weight of the projector and the wall mount before installation, and maintain the strength of the wall. If the wall is not strong enough, reinforce the wall before installation. ❏ The maximum combined weight of the projector and the wall mount is about 44 lb (20 kg). ❏ Do not hang cables over the wall mount. ❏ Install the wall mount so that it can sufficiently support the weight of the projector and wall mount, and resist any horizontal vibration. Use M10 nuts and bolts and make sure to use appropriate wall anchors for your wall type. Nuts and bolts smaller than M10 could cause the wall mount to fall. ❏ Epson accepts no responsibility for any damage or injury caused by lack of wall strength or inadequate installation. A Assemble the parts 1. Assemble the wall plate. Assemble the wall plate and two frames into one unit, and secure them with the M4 × 12 mm hexagon socket head cap bolts (×5) supplied. 23