Eureka Rally2 980AE Owner's Guide - Page 10

1. 2. 3. ENGLISH INSTRUCTIONS FOR USE • Before operating the vacuum cleaner, make certain that the dust bag and filters are in the proper position. 1 Pull all of the power supply cord out from back of cleaner and plug into electrical outlet. Note: When pulling on power supply cord watch for a yellow line on the cord. Then continue slowly pulling on cord till you see the red line, stop. The red line indicates the end of usable cord. 2 Push the ON/OFF ( I ) button to switch the cleaner on. 3 To rewind the power cord, press the rewind button with foot and guide the cord with hand to ensure that it does not whip causing damage. 5 The suction control button on the hose handle is used to reduce suction for delicate work such as cleaning drapes or picture frames. HOW TO USE Floors should be cleaned regularly over heavily traveled areas, and once a week over the entire area. Vacuum slowly, making several passes (forward and backward), covering small areas at a time. The time required to clean will depend on several factors - including type of floor and amount of dirt. CLEANING TOOLS 4* Combination Floor Nozzle: For carpets or hard surface floors. 5 Hose Suction Control Button: For use to increase or decrease suction when using cleaning tools. 6 Combination Crevice Nozzle/Brush Tool: (stored in rear of cleaner): For crevices, corners, baseboards, between cushions. Brush rotates to allow use as brush or crevice depending on task. *on some models. * Depending on model 4.* 5. Hose Suction Control Button 6. 10