Fisher and Paykel DD24DAX9 Installation Manual - Page 13

Secure To The Cabinetry On The Sides, Optionally Secure To The Cabinetry Above, Refit The Drawer

Get Fisher and Paykel DD24DAX9 PDF manuals and user guides View all Fisher and Paykel DD24DAX9 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

!1-B SECURE TO THE CABINETRY ON THE SIDES !2-B OPTIONALLY SECURE TO THE CABINETRY ABOVE For further adjustment, using the most appropriate length Hexagonal socket supplied, fully extend leveling feet up to required distance by hand. (x2) The top mounting brackets will only bend upwards a maximum of 3/8" (10 mm). Secure using two pairs of formed brackets (use 5⁄8" (16 mm) screws). Repeat on the other side of the chassis. x4 Hexagonal socket Ensure product is level and aligning with cabinetry. !3-B REFIT THE DRAWER ONTO THE RUNNERS 2 4 Lift or rotate counter-clockwise the drawer back onto the drawer runners on either side. 4" (100 mm) Before refitting the 3 drawer, ensure the hoses are not twisted and the latches at the rear of 1 each drawer runner are facing forward. Pull the release tabs forward on both sides 4" (100 mm). Ensure the tabs are fully pulled forward and click into place. Release tab 12

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
12
1
2
3
4
!1
-
B
SECURE TO THE CABINETRY ON THE SIDES
!2
-
B
OPTIONALLY SECURE TO THE CABINETRY ABOVE
x4
Secure using two pairs
of formed brackets
(use 5⁄8” (16 mm)
screws). Repeat on
the other side of the
chassis.
For further adjustment,
using the most appropriate
length Hexagonal socket
supplied, fully extend
leveling feet up to required
distance by hand.
Ensure product is level and
aligning with cabinetry.
Hexagonal
socket
(x2)
!3
-
B
REFIT THE DRAWER ONTO THE RUNNERS
The top mounting
brackets will only
bend upwards a
maximum of 3/8”
(10 mm).
4” (100 mm)
Pull the release tabs forward on both
sides 4” (100 mm). Ensure the tabs are
fully pulled forward and click into place.
Before refitting the
drawer, ensure the hoses
are not twisted and the
latches at the rear of
each drawer runner are
facing forward.
Lift or rotate counter-clockwise the
drawer back onto the drawer runners
on either side.
Release tab