Fisher and Paykel DD24DAX9 Installation Manual - Page 4
Optionally Hard Wiring Prior To Installation, Remove The Lower Drawer, Remove The Access Cover &
View all Fisher and Paykel DD24DAX9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
3 OPTIONALLY HARD WIRING PRIOR TO INSTALLATION 3-A REMOVE THE LOWER DRAWER 3-B REMOVE THE ACCESS COVER & REMOVE POWER To prevent kinked hoses Either sit the drawer down on the left hand side (recommended) or rotate the drawer clockwise, resting it on its side after removal. 3 3 1 2 4" (100 mm) 4 Push drawer runners back in on either side. Sit the drawer down 3 Press the release tabs in on either side and push back to release drawer from runners. Lift drawer off runners. 4 Push drawer runners back in on either side. Rotate the drawer clockwise (max. 90o) and rest on side. 1 Clip Access cover 1 Clip 1 With a flat-bladed screwdriver, push in the clips and slide out the access cover. 2 Unscrew the electronics module cover. 3 Carefully pull out the electronics module and rest on the chassis base out of the way. 4 With a screwdriver, unclip the plastic harness cover and hinge open. 5 Slide the terminal block cover sideways to unlock and hinge open to access the terminal block. 6 Unscrew the Live, Neutral and Earth wires as shown. 7 Unscrew the three screws on the base as shown and remove the cord from the product. 2 Electronics module 5 Terminal Block cover 4 Remove existing power cord 7 6 7 3