Fisher and Paykel DD24DCHTX9 User Guide - Page 44
How To Attend To A Fault
View all Fisher and Paykel DD24DCHTX9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
HOW TO ATTEND TO A FAULT START HERE Press to stop the beeping. If it's a 'A' code Note down the fault code. Look up the fault in the table opposite. If it's an 'F' code A1: Ensure the water supply is on, press again to clear the fault then press to resume the wash program. A3: Ensure the drainage hose and connection to pipes are not blocked. Press to clear the fault then press to resume the wash program. A09: (DD***C models only): Ensure the water supply is on. Press to clear the fault, then run the sanitize cycle again. A6: Open the drawer and check the spray arm. Has the spray arm loosened or come off its mounting? YES NO Refit the spray arm following instructions in section 'User maintenance instructions', then close the drawer, press again, then press to resume the wash program. Press . Wait a few seconds, then press again. Has the fault code disappeared? YES The fault has reset. You can continue to use your dishwasher. NO Has the fault code disappeared? Has the dishwasher resumed normal operation? YES NO You have corrected the fault and can continue to use your dishwasher as normal. Disconnect the dishwasher from the power supply (unplug or switch off at circuit breaker), turn off its water supply, then contact Customer Care with the fault code information. See your 'Service and warranty' booklet for contact details. 40