Fisher and Paykel DD24DCHTX9 User Guide - Page 45

Display, Possible Cause Of Fault

Get Fisher and Paykel DD24DCHTX9 PDF manuals and user guides View all Fisher and Paykel DD24DCHTX9 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 45 highlights

HOW TO ATTEND TO A FAULT DISPLAY (DD***C models only) DISPLAY X X X X X X X X X POSSIBLE CAUSE OF FAULT No water - the water supply hasn't been turned on. Drawer cannot drain. The drainage hose may be blocked or kinked, or the connection to drainage pipe may be blocked. The spray arm has loosened or come off its mounting, or water pressure is too low. Sanitize cycle hasn't met temperature needed to sanitize dishes. The wash may have been interrupted during the cycle, or the water supply may have been turned off. See section 'Setting wash modifiers' POSSIBLE CAUSE OF FAULT Flood detected. Motor fault. Temperature fault. You may need to have a tempering valve installed on your water supply, to ensure that incoming water is less than 65oC/149oF. Heating element failed. Fault with the internal lid of the dishwasher. Component failure. Fill valve fault. Electronics fault-motor controller. Electronics fault-wash controller. Electronics fault-communication between drawers. 41

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
41
HOW TO ATTEND TO A FAULT
DISPLAY
POSSIBLE CAUSE OF FAULT

No water – the water supply hasn’t been turned on.

Drawer cannot drain. The drainage hose may be blocked or
kinked, or the connection to drainage pipe may be blocked.

The spray arm has loosened or come off its mounting, or
water pressure is too low.

(DD***C models only)
Sanitize cycle hasn’t met temperature needed to sanitize
dishes. The wash may have been interrupted during the
cycle, or the water supply may have been turned off. See
section ‘Setting wash modifiers’
DISPLAY
POSSIBLE CAUSE OF FAULT

Flood detected.

X
Motor fault.

X
Temperature fault. You may need to have a tempering valve
installed on your water supply, to ensure that incoming
water is less than 65
o
C/149
o
F.

X
Heating element failed.

X
Fault with the internal lid of the
dishwasher.

X
Component failure.

X
Fill valve fault.

X
Electronics fault—motor controller.

X
Electronics fault—wash controller.

X
Electronics fault—communication between drawers.